BrewZilla 2 Inch Tri-Clamp Steam Condenser Set
This steam condenser lid is compatible with the 35L or 65L BrewZilla/DigiBoil with the stainless distillation lid and 2 Inch Bulkhead. This unit can allow brewing indoors without that pesky sticky steam gumming up your freshly painted interior! The End Cap can be removed for brewing salts/hops and other brewing essentials to be added during the boil. Please note, hot steam through this port can lead to serious scalding, please use heatproof gloves.
Not only will you get to the boil faster, but you will use less power overall to maintain a rolling boil as there will be less area for the heat to escape. No need to install inside a kitchen, or in the garage with a special rangehood. Simply attach this to the Condenser Lid and run your kitchen tap or garden hose to the inlet. You don't not need super-fast flow rate to cool boiling steam into liquid. Different to distillation where you require the distillate to be under a certain temperature so that ethanol doesn't evaporate from the liquid at a high rate, with boiling wort you just need enough to form a liquid! Pretty simple.
Eco-Friendly option if you have the means to save/collect the coolant water. Can be re-used on the garden or for cleaning later on. Please note the water discharging will be very hot!
The Spray head can condense 1.6 litres per minute while connected to 100 psi mains water.
This Condenser kit includes:
5 x 2 Inch Tri-Clamp Clamps
5 x 2 Inch Tri-Clamp Double Beaded Silicone Seals
1 x 340mm Long 2 Inch Tri-Clamp Tee
1 x 200mm Wide 2 Inch Tri-Clamp Tee
1 x 2 Inch Tri-Clamp End Cap
1 x 2 Inch Tri-Clamp to 6.5mm Duotight elbow cap with elongated spray head mister
1 x 2 Inch Tri-Clamp x 12mm Barb (Suitable for 10mm ID Silicone Hosing)
Some of these fittings are not sold separately
Does not include:
Garden hose / Kitchen Hose fittings to 6.5mm duotight. One of the photos shows a way to connect a 6.5mm x 1/2" female to a 1/2" Male Hex Nipple to a Male Garden hose fitting.
From: Kegland
